12 User’s Guide
When you have correctly Force Armed the system, the
Exit Delay will start (see section 4.1) and the ARM Light
will turn on.
4.6 BYPASS PROGRAMMING
Bypass Programming allows you to program the system
to ignore (deactivate) specified zones the next time the
system is armed. For example, you can bypass certain
zones when you are renovating. The Fire Zone and
zones that are not Bypass Enabled by your installer
cannot be bypassed.
How Do I Force Arm?
1) Close all zones except Bypass Enabled Zones.
2) Press the [FORCE] button
3) Enter your [ACCESS CODE]
How do I Bypass Zones?
1) Press the [BYP] button.
2) Key in a valid [ACCESS CODE]
3) Press the button(s) corresponding to the zones that
you want to bypass. Illuminated buttons represent
bypassed zones. To unbypass a zone, press its
corresponding button to extinguish it.
4) Press [ENTER].
To Next Page
Loading...
Need help?
General
