Programming
Programming Overview:
After pressing the PROGRAM key, the EL74 will continue to control the outputs based on the
events that were operating at the time the PROGRAM key was pressed. The control will not
check for new events until it has gone through a status update.
The control remains fully functional after pressing the REVIEW key, provided the REVIEW key
was not pressed while in the programming mode.
During operation, the control will be in the RUN mode. When programming (or reviewing), the
order of the program headers and steps is as follows:
TIME - set time, date, Daylight Savings Time
CONF - 12/24, stagger up, durations 1-4, duty cycles 1-4
ASTR - sunrise, sunset, latitude, hemisphere
EVNT - on, off, durations 1-4, duty cycles 1-4
INPT - configure inputs
EVNT SENS - sensor events
HOL - set holidays
From the HOL header, the control will loop around to the TIME header. The OVER (override)
mode is only accessible from the RUN mode. The following is a detailed explanation of each
mode.
16
To Next Page
Loading...