RUN
The RUN mode is the normal operating mode. In the RUN mode
the current time and day are shown. If today is a holiday, the
active holiday schedule is also shown. Channel status is shown on
the bottom line. The channel number is shown if that channel is
on. If the channel number is flashing, that channel is currently
overridden. If it is flashing mostly on, the channel is overridden on.
If it is flashing mostly off, the channel is overridden off. The input #
is also shown along with the status of that input. The following is a
list of the possible input status messages:
Message Input Config. Status
NONE not config --
On\d On\d input closed
OFFd On\d input open, in delay
-N- On\d not active
OVd OVR overridden on w/delay
?-V- OVR not active or overridden
on or off without delay
ENb ENb input closed (enabled)
dISb ENb input open (disabled)
072F sensor,F sensor value
LO F sensor,F sensor value below range
(continued on next page)
35
To Next Page
Loading...