Program the day that Daylight Savings Time ends. The control
defaults to the last Sunday in October. At 2:00 AM on this day, the
control’s time will go back one hour.
Configuration
Configuration header. This mode is used for changing the clock
format, selecting stagger up, setting the lengths of the 4 durations
and for programming the on/off times of the 4 duty cycle patterns.
Use the NEXT key to begin programming.
Select 12-hour or 24-hour clock format using the +/- key.
Select the stagger up time between channels. This stagger up
occurs after a power outage and after a status update. The follow-
ing stagger up selections are available:
NO = not used 01.00 = 1 minute
00.05 = 5 seconds 05.00 = 5 minutes
00.15 = 15 seconds 10.00 = 10 minutes
00.30 = 30 seconds 15.00 = 15 minutes
19
To Next Page
Loading...