Override
Keyboard Override header. This mode is reached by pressing the
OVERRIDE key from the RUN mode. Press the NEXT key to con-
tinue in this mode or press the RUN key to exit this mode without
affecting a change to the load status.
This screen shows the status of all channels on the bottom line of
the display. If the channel number is flashing, the channel is cur-
rently overridden. If it is flashing mostly on, the channel is overrid-
den on. If it is flashing mostly off, the channel is overridden off. The
channel # currently pointed to will be flashing in the upper right
hand corner of the display. The current event for this channel is
shown below the channel # (e.g. ON, OFF, dUR2, CYC4, SC03,
NONE). Press the OVERRIDE key to toggle the channel status until
the next event. Press the RUN key to cancel an override (will not
work for timed external overrides). Press the +/- keys to select the
next/previous channel. To exit the override mode without making a
change, press the PREVIOUS or NEXT key to return to the override
header, then press the RUN key.
34
To Next Page
Loading...