Parallax BASIC Stamp 2e - Using the Basic Stamp Editor

3: Using the BASIC Stamp Editor
BASIC Stamp Programming Manual 2.0c • www.parallaxinc.com • Page 33
The BASIC Stamp Editor software is available for Windows and DOS
operating systems. The following system requirements are a minimum for
using the BASIC Stamp Editor:
• 80486 (80286 for DOS) (or higher) IBM or compatible PC;
• Windows 95/98/NT4/2000 operating system (DOS 5.0 or
higher for DOS versions);
• 16 Mb of RAM (1 Mb for DOS);
• 1 Mb of available hard drive space;
• CD-ROM drive;
• 1 available serial port (1 available parallel port for BS1).
(Note: though it is suggested that the BASIC Stamp Editor be installed on your hard drive, it
is not required. The software may be run right off the Parallax CD).
To install the BASIC Stamp Editor:
1. Insert the Parallax CD into the CD-ROM drive. The CD
should auto-start (unless that feature has been disabled on
your computer). If using DOS, explore it with the CD (change
directory) and DIR (directory list) commands.
2. Select the Software -> BASIC Stamp section.
3. Select the DOS or Windows version you wish to use and click
the Install button. If exploring the CD through DOS, use the
COPY command to copy it to a desired directory on your hard
drive.
4. Close the CD and run the BASIC Stamp Editor program from
the directory it was copied to. You may also create a shortcut
to it (if using Windows).
Table 3.1 lists the available BASIC Stamp editors, their names, versions,
operating system and BASIC Stamp model they support.
DOS Software Windows Software
BS1
Stamp.exe
N/A
BS2
Stamp2.exe
Stampw.exe
BS2e
Stamp2e.exe
Stampw.exe (v1.096+)
BS2sx
Stamp2sx.exe
Stampw.exe (v1.091+)
BS2p
Stamp2p.exe
Stampw.exe (v1.1+)
Table 3.1:
BASIC Stamp Editors for
DOS and Windows.
SYSTEM REQUIREMENTS FOR THE
BASIC STAMP EDITOR SOFTWARE.
I
NSTALLING THE SOFTWARE.