PARAMOUNT BED CA-53380 - Troubleshooting Guide

50
●
To clean the bed, use a cloth that has been soaked in diluted detergent and wrung out well, then wipe
off any residual detergent with a cloth soaked in water and wrung out well. Finally, use a dry cloth to
wipe the bed to ensure it is dry.
76.9% - 81.4% ethanol for disinfection
0.05% - 0.2% benzalkonium chloride (e.g. Osvan)
0.05% - 0.2% benzethonium chloride (e.g. Hiamine)
0.05% chlorhexidine gluconate (e.g. Hibitane)
0.02% - 0.05% sodium hypochlorite (e.g. Milton)
■Lubrication (if there is abnormal noise)
●
Lubrication is needed if there is abnormal noise. Please feel free to contact Paramount Bed or
your distributor to be lubricated.
●
The water adhesion to the bed or the mattress, or moisture may cause corrosion, abnormal
noise or contamination. If water adhere to the bed or the mattress, wipe off immediately.
●
Do not use volatile cleaning fluids (such as paint thinner,
benzene or gasoline) and cresol. Discoloration or
deterioration could result.
●
The product cannot be used with an ozone sterilizer or an autoclave sterilizer,etc.
■Bed unit
●
Always dilute any detergents used as specified below.
●
To prevent accidents caused by incorrect operation, always unplug the power plug from the outlet
before cleaning.
●
Do not splash water to clean the bed. there is a risk of electric shock due to a short circuit.
■Accessories
●
Follow the instructions described in the instruction manual for the respective accessory.
REGULAR INSPECTION AND DAILY MAINTENANCE
11