InspectRx200 Operator Guide | 2 - InspectRx Preventative Maintenance Guide | 59
This is a checklist to accompany the InspectRx PM Process QC0075
Confidential Property of Parata
This material cannot be copied or disclosed to others without the prior written permission of Parata.
This document and the information contained herein is provided on an “As Is” basis and Parata
disclaims all warranties, express or implied, including but not limited to any warranty that the use
of the information herein will not infringe any rights or any implied warranties of merchantability
or fitness for a particular purpose. Parata reserves the right to make changes to the content of this
manual, at any time, without obligation to notify any person or entity of such changes. Those wishing
to reproduce and/or use this text for purposes other than above authorized, are requested to apply in
writing or directly contact:
Parata
106 Roche Dr.
Durham, NC 27703
www.parata.com
Table 4. InspectRx PM Process checklist
Replaced the Main Belt?
Replaced the Infeed Belt?
Dome Brushes Replaced?
Dome Gas Spring Replaced?
Was the Door Closure (SB2) installed?
Was the upper dome latch installed?
Was the grounding upgraded on the bottom and top dome?
Belt Alignment and Verification completed?
Were the folds eliminated on the bags during transport?
***PERFORM THE REST OF THE PM WITH TCG SUPPORT***Employee Name:
Is the Bottom Camera Aligned with less than 2mm Between the lens and the bottom dome?
What is the bottom lens MM setting (6,8 or 12mm)?
Is there open blank spacing along the top and the bottom of the top image?
Bottom Camera Calibrated with calibration card?
Top Camera Calibrated with Calibration Card?
How many MM between the Edge of the paper and the belt mark?
Were the barcode Sync Settings set per defaults?
To Next Page
Loading...