InspectRx200 Operator Guide | 1 - InspectRx200 Operator Guide | 5
Power Cycle and Restart Procedure
InspectRx Series Shutdown Procedure:
1. Turn the Corrector Station off
• Close out all open Corrector applications
• Go to Windows menu and select shutdown
2.
Turn the Viewer Station off
• Close out all open Viewer applications
• Close out all open remote desktop connections
• Go to Windows menu and select shutdown
3.
Turn the Operator off
• Press and release the OPE button on the lower right side of unit
• Press and release the ANA button on the lower right side of unit
**IMPORTANT**‐
Wait until both lighted buttons are no longer illuminated
4. Press the red power button upward to turn the unit off (the power button llumination should be
off)
InspectRx Restart Procedure:
1.
Restart the Operator Computer
• Press and release the OPE button on the lower right side of unit
• Press and release the ANA button on the lower right side of unit ** IMPORTANT** -
Wait until both lighted button are no longer illuminated
• Press the red power button below buttons upward to turn off (the power button illumination
should be off)
2. Let InspectRx sit for a two minutes, then
3.
Turn the Operator on
• Press the red power button downward on the lower right side of unit to turn on (the button
should illuminate)
• Press the ANA button (button should illuminate)
• Press the OPE button (button should illuminate)
• Wait for unit to boot up and sign in (software should automatically startup after sign in) **
IMPORTANT**
‐
Wait for Operator
boot‐
up before continuing
4.
Restart the Viewer
• Close out all open Viewer applications
• Close out of any open remote desktop connections
• Go to Windows menu and select restart
• Wait for unit to reboot
• Open the Viewer Application
5.
Restart the Corrector
• Close out all open Corrector applications
• Close out all open Batch Validator applications (if applicable)
• Go to Windows menu and select restart
To Next Page
Loading...