Why is there a constant bleed from control solenoid top exhaust port on Parker Dehumidifier?
A constant bleed from the control solenoid top exhaust port on your Parker Dehumidifier indicates that the associated inlet or exhaust valve is defective (rebuild or replace) or the control solenoid is dirty or defective (clean or replace).
General| Brand | Parker |
|---|---|
| Model | Airtek TW 100 |
| Category | Dehumidifier |
| Language | English |
Guidelines for inspecting the dryer upon arrival and selecting an optimal installation site.
Key requirements for proper installation, including piping and pre-filtration.
Crucial safety measures including caution, pressure relief, and PPE.
Verifying wiring, power, and initial pressurization before system activation.
Introduction to the Powerloc digital dew point monitor for load-tailored cycles.
Addresses problems like no operation, incorrect switching, and timing faults.
Solutions for high dewpoint, downstream moisture, and air leaks.
Troubleshoots valve leaks, pressure issues, control air, and solenoids.
Initial setup and operational principles of the PowerLoc dew point monitor.
Instructions for mounting the sensor probe and connecting it to the analyzer.
To Next Page