Product Description LCB Compact Linear Actuator
24 192-510014 N04 March 2010
4.1 Product Design
The LCB is protected by registered design No. 20 2004 014 821.8 20 2004 014 821.8
The external sliding guide is incorporated as part of the aluminium profile. It is
unnecessary to adjust two separate guiding rails.
The sliding carriage is available in three lengths. With a longer sliding carriage
there is greater distance between the sliding blocks (3) and this improves the load
capacity with respect to yawing and pitching moments.
Maintenance-free sliding guiding with integrated dry-film lubricant.
Sliding carriage (3) can be easily changed within 2 minutes without detensioning
the timing belt.
The toothed belt of LCB40 is tensioned directly at the sliding carriage by means
of spacer plates (4).
On the LCB060, the toothed belt is tensioned via tensioning screws at the
tensioning station (5).
The low moving mass allows highly-dynamic movement to be achieved and
saves operating power.
Available in 2 sizes
High resistance to flexing
High torsional stiffness due to the closed profile
Compact design, minimum installation space required
Dirt tolerant, chemically and mechanically robust
High stiffness and accuracy provided by the generously-dimensioned toothed
belt.
Drive options:
Linear actuator with free shaft end
Coupling (9) and gearbox
Coupling, gearbox and motor (stepper or servo)
Coupling, gearbox, motor and controller
Coupling and direct-drive motor (10) with Compax3.
Guide (1) / sliding
carriage (2):
Profile (6):
Timing belt drive (7):
Drive (8):
To Next Page
Loading...
