Parker 890CS User Manual

HA468445U001: 890 Engineering Reference
Product Manual : Frames B, C & D
HA468445U001 Issue 8
Compatible with Software Version 1.10 onwards
2007 Parker SSD Drives, a division of Parker Hannifin Ltd.
All rights strictly reserved. No part of this document may be stored in a retrieval system, or
transmitted in any form or by any means to persons not employed by a Parker SSD Drives
company without written permission from Parker SSD Drives, a division of Parker Hannifin Ltd .
Although every effort has been taken to ensure the accuracy of this document it may be necessary,
without notice, to make amendments or correct omissions. Parker SSD Drives cannot accept
responsibility for damage, injury, or expenses resulting therefrom.
WARRANTY
Parker SSD Drives warrants the goods against defects in design, materials and workmanship for
the period of 12 months from the date of delivery on the terms detailed in Parker SSD Drives
Standard Conditions of Sale IA058393C.
Parker SSD Drives reserves the right to change the content and product specification without
notice.

Parker 890CS Specifications

General

Model	890CS
Protection Class	IP20
Communication Protocol	CANopen
Number of Axes	1
Operating Temperature	0°C to 55°C

Summary

890 Engineering Reference

Product Manual: Frames B, C & D

Specifies the product manual for 890 drives covering Frames B, C, and D.

Warranty Information

Chapter 1: Safety Information

General Safety Notes

Important safety notes to be read before installing and operating the equipment.

Product Warnings and Hazards

Highlights product warnings and potential hazards to personnel and equipment.

Safety and EMC Considerations

Chapter 2: Getting Started

Initial Steps for Unit Setup

Covers planning for installation, operation, and programming of the unit.

Chapter 3: Product Overview

Product Range and Types

Introduces the 890 range of products: Common Bus Supply, Common Bus Drive, Standalone Drive.

Keypads for 890 Series

Chapter 4: 890CS & 890CD Common Bus Units

Chapter 5: 890SD Standalone Drive

Step 1: Mechanical Installation

Covers cubicle layout, main points, and enclosure sizing for 890SD drives.

Step 2: Connecting Power

Details power connection procedures and earth/ground fixing requirements.

Step 3: Control Connections

Explains main points and provides control connection diagrams for 890SD drives.

Step 4: Checking the System

Covers pre-operation checks and powering up the 890SD unit with 24V DC.

Step 5: Run the Motor

Guides through running the motor, including pre-operation checks and autotuning.

Chapter 7: Operating the Drive

Control Philosophy

Start/Stop and Speed Control

Starting and Stopping Methods

890CD/SD 4-Q Regen AFE Applications

Chapter 8: The Keypad

6511 Keypad Overview

6901 Keypad Overview

Control Key Definitions

Explains the operation and description of each control key on the keypad.

Selecting Local or Remote Mode

Chapter 9: Keypad Menus

890CS Common Bus Supply Keypad Menus

890 Common Bus/Standalone Drive Keypad Menus

Chapter 10: Trips and Fault Finding

Trips Overview

Explains what happens when a trip occurs and provides drive and keypad indications.

Resetting a Trip Condition

Describes procedures for resetting trips in Local and Remote modes.

Trips Table

Fault Finding Guide

Provides a troubleshooting guide for common drive problems and their remedies.

Appendix D: Programming

Programming with Block Diagrams

Function Block Descriptions

Parameter Specification Tables

Appendix E: Technical Specifications

Understanding the Model Number

Electrical Ratings

Provides detailed electrical ratings for different 890CS, 890CD, and 890SD frames and voltages.