Parker 890CS - Alert Messages

Trips and Fault Finding
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page 10-19
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
Alert Messages
A message will be displayed on the Keypad when either:
♦ A requested operation is not allowed
♦ The drive has tripped
The table below lists the messages and the reason for each message.
Alert Message IDs
ID Message Reason
6901 Keypad 6511 Keypad
0 No Alert
1
RUNTIME ALERT
XXXX YYYYYYYY
XXXX Runtime alert
2 SAVING SAVE Saving to flash
3 LOADING LOAD Loading from flash.
4 LIMIT REACHED HI High or low limit reached while editing.
5
KEY INACTIVE
RUN FORWARD TRUE
RUN Can’t switch to remote mode.
6
KEY INACTIVE
RUN REV TRUE
RUN Can’t switch to remote mode.
7
KEY INACTIVE
JOG TRUE
JOG Can’t switch to remote mode.