Parker 890CS - Mechanical Brake

Associated Equipment
Page 6-18 890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
Mechanical Brake
Brake motors provide a parking brake. The brake
can be either mechanical where the user
opens/closes the brake, or electro-mechanical
where the braking is handled automatically by the
drive.
The electro-mechanical parking brake is
controlled by the output of terminal X06 on the
890CD.
•
Connect a 24V dc supply to terminals
X06/01 and X06/02 as shown.
•
Connect the brake to terminals X06/03 and X06/04.
IMPORTANT Engaging the brake when the motor is turning will increase its wear. This may lead to brake failure.
Refer to Appendix D: "Programming" - MECH BRAKE to configure the drive for use with the brake.
To navigate to MECH BRAKE on the keypad:
SETUP::MOTOR CONTROL::MECH BRAKE
01
02
03
04
X06
+24V dc in - user supplied
- 0V dc
+ Brake
- Brake
Coil
Internal
Brake
Relay