K3.1.142k Manual NitroFlow Lab - 21 -
6.3.4 Options menu
Access: Press option menu button in settings screen (refer to §6.3)
Function: Set different options
ATTENTION:
All options are default set to NO. Options do not affect the output and purity.
Button Selection Result
Auto R. Yes After a power failure the unit will automatically restart itself and
return to the same situation/status.
Auto R. No After a power failure the unit will not start automatically. Unit
needs to be restarted manually.
Remote Yes Unit can be switch on and off from a remote location. Only
select Yes after connecting the printed circuit board to an
external device.
Remote No Unit cannot be controlled from a remote location.
Pincode Yes Settings are instantly protected with a pin code. Return to log
on menu
and enter the default pin code 1234.
Pin code No Settings can be changed without a pin code
Pin code Change Pin code can be changed to a personal 4 digits code. (In case
you forget your personal code, consult your supplier)
Show Flow Yes Flow rate will be displayed in main screen
Show Flow (D) No Flow rate will not be displayed.
Operate to adjust date and time
6.3.5 Local settings menu
Access: Touch local settings menu button in settings screen
(refer to § 6.3)
Function: Set data to local requirements
Depending on the local situation it is possible to change the setting accordingly.
To Next Page
Loading...
