6
GB/IE/NI/CY/MT
Dispose of the device and packaging in an environmentally friendly manner!
You are legally obliged to place devices marked as such in a collection which is
separate from unsorted municipal waste. Disposal through household waste is
prohibited.
Made from recycled material
Do not dispose of any electrical devices in domestic waste!
The heated glow wire poses a high risk of danger. If touched this can cause burns.
Wear protective goggles.
Wear protective gloves.
Keep away from rain.
130
Thermal circuit breaker
Glow Wire Hard Foam Cutter PGDH A2
z Introduction
Congratulations! You have purchased one of our high-quality products. During production
this device was checked for quality and subject to a final inspection. This ensures that your
device is working properly. Please familiarise yourself with the product before using it for
the first time. To do so, please read through the following operating and safety instructions
carefully. Use the product only as described and only for the specific applications as stated. Ensure you
hand over all documentation when passing the product on to anyone else.
KEEP OUT OF THE REACH OF CHILDREN!
z Intended use
The glow wire hard foam cutter is intended to be used exclusively for cutting polystyrene hard foam panels
(e.g. facade insulation panels, roof insulation panels). You must not cut other materials. The wire is
heated up by an electrical transformer and will heat up to 360°C in approx. 3 seconds. Any polystyrene
hard foam material which touches the wire will melt. In this way, it forms edges which are completely
To Next Page
Loading...
