Parkside PHD 170 D2 - Page 35

GB
MT
35
• System separator
A system separator (check valve)
prevents the backflow of water and
cleaning agent into the drinking
water pipeline.
• According to current regulations,
a pressure washer must nev-
er be connected to the drink-
ing water network without a sys-
tem separator. A suitable sys-
tem separator must be used in
accordance with EN12729 Type
BA.
• Water that has flowed through a
system separator is classified as
non-potable.
• System separators are available
from specialist dealers.
Procedure
1. Insert the filter insert (20) in the
water connection (21).
2. Fit the coupling (19) on the water
connection (21).
3. Attach the quick connector with
garden hose adaptor (31) to the
supply hose.
• Remove the grooved clamping
nut.
• Push the clamping nut over the
end of the hose.
• Insert the end of the hose into
the thread of the quick connect-
or with garden hose adaptor.
• Fix the quick connector with
garden hose adaptor with the
clamping nut.
• Check whether the quick con-
nector with garden hose adaptor
is fitted securely to the hose.
4. Connect the supply hose to the
water supply.
5. Bleed the supply hose: Open the
water supply until the water flows
bubble-free out of the other end of
the supply hose. Close the water
supply.
6. Connect the quick connector with
garden hose adaptor (31) on the
supply hose to the coupling (19).
Suctioning water
Requirements
• NOTICE! Contamination from
backwashed cleaning agent! Do
not draw in any water from natural
accumulations.
• Suction hose with filter basket
(not included, Spare parts and
accessories, p.44)
• standing, clean water, e.g. rain bar-
rel
• Max. suction height: 0.5m
Procedure
WARNING! Electric shock! The
device itself must not be submerged
in the water collector.
NOTICE! Damage due to dry running!
Ensure there is a sufficient and reli-
able water supply.
1. Connect the suction hose with fil-
ter basket to the coupling (19) on
the water connection (21) of the
device.
2. Insert the end with the filter basket
into the water collector.
3. Remove the lance (1) from the trig-
ger gun (6).
4. Press and hold the switch lever
(24).
5. Move the On/Off switch (4) to the
position “I” (ON).
The device begins to suction water
and air can escape.
6. Once the device is free of air, you
can release the switch lever.
7. Fit an attachment.