32
GB MT
Technical data
Cordless Angle
Grinder ...............
.............................
.................... 10000 min
Cutting / roughing / grinding discs /brushes
Outside diameter
Grinding wheels /
Disc brushes ............ max. Ø 125 mm
Bore hole ............................ 22.23 mm
Grinding wheels ..............max. 6 mm
...............
Disc brushes .................... max. 5 mm
designs .....................
................bonded, reinforced, segmented
Spindle thread .............................
.............................. 11 mm
(L
pA
........................87.1 dB; K
pA
= 3 dB
WA
measured .............. 95.1 dB; K
WA
= 3 dB
h
..3.44 m/s
2
;
K= 1.5 m/s
2
Handle ........... 3.79 m/s
2
;
K= 1.5 m/s
2
.
Charging process ...................
Operation ..........................
Storage .................................
For use with smart batteries
Operating frequency/
Frequency band ....
.......
generated by the cutting discs supplied.
pending on the used accessories.
the handling for the user‘s.
Cutting disc ................... WA60 T BF
Idling speed n
max
..................12200 min
0
............................80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22.23 mm
................................ 1.2 mm
*
The cutting disc must withstand a rotational
speed of 80 m/s.
measured according to a standardised test
method and can be used to compare one
power tool with another.
the load.
Warning:
power tool, depending on how the power
tool is being used and, in particular, what
kind of material is being worked on.
Safety measures for the protection of
the operator are to be determined that
are based on an estimate of the actual
conditions (for this, all parts of the opera
ting cycle are to be taken into account, for
example, times in which the electric tool is
turned off, and those during which it is tur
Charging time
series may only be charged using chargers
To Next Page
Loading...
