45
GB MT
If the rotary direction is indi-
cated on your disc, ensure
that it corresponds to the rotary di-
rection of the angle grinder when
mounting. This is indicated on the
device below the spindle stop but-
ton (9) (
).
spindle lock button holds the uptake
Installing/changing the
wire brush
spindle stop button holds the mounting
3. Release the wire brush with a combina
tion wrench (not included in the scope
4. Place the desired wire brush onto the
mounting spindle.
rotate the wire brush on the mounting
using a combination wrench. You can
Operation
Caution! Risk of injury!
cessories recommended by the manufac
turer. Using other attachment tools and
other accessories can represent a risk of
injury for you.
information about the manufacturer, type
of connection, dimension and permitted
printed rotational speed is at least as
otherwise damaged diamond cutting/
grinding discs.
- Support the plates or workpieces in or-
der to reduce the risk of kickback from a
jammed cutting disc. Large workpieces
workpiece must be supported on both si
des of the disc, not only near the cutting
disc, but also at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
Information
on replacement:
the tool is the same or higher than the
To Next Page
Loading...
