44
GB MT
Removing the cutting disc/
grinding disc/brush:
le. Keep and continue to hold down
nut open by hand or by loosening it
grinding wheel/brush from the uptake
Attaching the guard cover:
that the open side faces the tool.
into the grid on the tool, only one posi
tion is possible.
time.
rator.
4. Readjust the position of the guard co
Removing the guard cover:
past the resistance, until the open side
match the grid on the tool, then you
wards.
Fitting the attachment
to/removing the
attachment from the
protective cover
Fitting the attachment
1. Fit the attachment onto the guard
2. Push the attachment onto the gu
until it clicks into place.
Removing the attachment
1. Release the attachment by pushing
the notch away from the guard
2. Unscrew the attachment from the
Installing/changing disc
the wheel, see chapter “Fitting the attach
le. Keep and continue to hold down
nut open by hand or by loosening it
place the desired wheel on the moun
To Next Page
Loading...
