37
GB MT
ies can be unpredictable and lead to
or elevated temperatures. Fire or
explosion.
g) Follow all instructions for charg-
ing and never charge the bat-
tery or the battery-powered tool
outside the temperature range
stated in the operating instruc-
tions. Incorrect charging or charging
outside the permitted temperature range
may destroy the battery and increase
6) Service
a) Have your power tool serviced
-
ing only identical replacement
parts.
of the power tool is maintained.
b) Never repair damaged batter-
ies. All battery repairs should be car
ried out by the manufacturer or author
Safety instructions for all
applications
Common safety instructions for
grinding, working with wire bru-
shes and cutting grinders:
a) This electric tool is to be used as
a grinder, wire brush and cutting
grinder. Follow all safety instruc-
tions, directives, illustrations and
facts which you receive with the
device. If you do not follow these inst
serious injury may occur.
This power tool is not suitable
for sanding, polishing or hole
cutting. Using the electric tool in ways
for which it is not intended may cause
hazards and injuries.
Do not use the power tool for
any function for which it is not
expressly designed and inten-
ded by its manufacturer. Such
and serious bodily injury.
Do not use any attachment tools
-
ded and recommended for this
power tool by the manufacturer.
Attaching the accessories to the power
tool does not guarantee safe operation.
e) The allowable rotation speed
of the attachment tools must be
at least as high as the highest
rotation speed indicated on the
electric tool. Accessories that run fas
ter than the allowable speed can break
f) The outside diameter and thick-
ness of the attachment tool must
correspond to the dimensions
indicated for your electric tool.
Attachment tools which are wrongly
shielded or controlled.
The dimensions for fastening the
attachment tool must match the
dimensions of the fasteners of
the power tool. Attachment tools
which cannot be precisely attached to
a loss of control.
h) Never use damaged attachment
tools. Check attachment tools
such as grinding discs for chip-
ping or cracks, grinding plates
for cracks, wear or strong abrasi-
on and wire brushes for loose or
To Next Page
Loading...
