41
GB MT
Special safety instructions
for working with wire
brushes
Be aware that the wire brushes
also lose wire pieces during typi-
cal use. Do not overload the wi-
res by pressing down too hard.
rate thin clothing and/or your skin.
If a protective hood is recom-
mended, do not allow the wire
brushes and the protective hood
to touch each other.
of plate and cup brushes can enlarge if
too much pressure and centrifugal force
is exerted.
Additional safety
instructions
dicated rotational speed is at least as
grinding disc before use. Do not use
any damaged or deformed grinding
discs. Replace any damaged or worn
grinding discs.
grinding do not present a danger, e.g.
tances.
protection when grinding, brushing and
cutting.
grinding disc and spark protection or in
slipping which could cause your hands to
come into contact with the grinding disc.
Do not touch the machined area, allow
ning. Do not use coolants or the like.
cohol or tablets, do not work with the
entangled,
the guard and the workpiece may interfe
control.
is an increased risk of being exposed to
the ejected sparks and grinding partic
les as well as fragments of the grinding
breakage.
or side grinding in concrete or mason
ry, there is an increased risk due to
dust exposure as well as loss of control
with kickback as a consequence.
may cause the wires to break.
To Next Page
Loading...
