47
GB MT
After switching on, wait until the tool has
reached its max. speed. Only then should
you start with the work.
The tool still runs even after
the device has been switched
off. There is a risk of injury.
If the wheel is blocked for
longer than approx. 4 se-
-
shes. The tool must be switched off
and switched on again. If blocked
for less than that, the wheel starts
back up automatically.
ration.
Trial run: Always carry out a trial run
without a load before carrying out your
change. Switch the tool off immediately
if the tool is not rotating smoothly, if con
abnormal noises.
Connecting the device
to the Parkside app
Only Smart Performance batteries
can be connected to the Parkside
the battery.
1. Place a Smart Performance
place.
.
the charger (18 from the mains power
supply.
5. Pull the battery (17 out of the charger
(18.
Overview of the LED indicators on
the charger (18):
Green LED lights up without battery inser-
ted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED ashes:
Red + green LEDs ash:
Selecting the speed
Switching on and off
Switching on
light up.
succession.
Switching off
You can also use the On/Off switch
as a pushbutton. Press the
hold the on/off switch.
switchagain.
To Next Page
Loading...
