6．After the engine starts, slowly return the manual starter handle to its original position before
releasing it. Immediately after the engine starts,release the main switch and allow it to return to
“ON”(on).
7．Slowly return the throttle grip to the fully closed position.
NOTE:
Never turn the main switch to “START”(start)while the engine is running.
Do not keep the starter motor turning for more than 5 seconds. If the starter motor is turned
continuously for more than 5 seconds, the battery will be quickly discharged,thus making it
impossible to start the engine. The starter can also be damaged. If the engine will not start after
5 seconds of cranking, return the main switch to “ON”(on), wait 10 seconds,then crank the
engine again.
NOTE:
When the engine is cold, it needs to be warmed up.
If engine does not start on the first try, repeat the procedure. If the engine fails to start after 4 or 5
tries,open the throttle a small amout (between 1/8 and 1/4), and try again.
For T40/30FW
1. Place the remote control lever in neutral.
NOTE:
The start-in-gear protection device prevents the engine from starting except when in neutral.
19
To Next Page
Loading...
Need help?
General
