Need help?Do you have a question about the ParTech 7200 and is the answer not in the manual?
General| Model | 7200 |
|---|---|
| Manufacturer | ParTech |
| Color | Black |
| Type | Enclosure |
| IP Rating | Unspecified |
Describes the monitor, its display, keypad, and general operation.
Details alarms, analogue output, and compatible sensors.
Guidance on selecting an appropriate location and mounting the 7200 Monitor.
Details on making the necessary electrical connections to the monitor.
Describes the primary operating mode of the 7200 Monitor.
Explains the instrument's background measurement process.
Details the information shown on the monitor's display.
How to navigate the instrument's menu system.
Methods used for entering and setting parameters.
Selecting options from predefined lists.
Entering numerical values for settings.
Entering text for titles and units.
Importance and general guidelines for instrument calibration.
Describes Primary and Secondary calibration methods.
Steps to ensure successful calibration.
Guided process for calibrating the instrument.
Procedure for setting the zero point of the instrument.
Procedure for setting the span (calibration point) of the instrument.
Stores sensor signal for retrospective calibration.
Enters known calibration solution value.
Setting the threshold value for an alarm condition.
Configuring the type of alarm (Low, High, Fault, Off).
Setting the difference between alarm on/off points.
Defining which faults trigger a fault alarm.
Introducing a delay before an alarm becomes active.
Introducing a delay before an alarm becomes inactive.
Verifying the operation of alarm outputs.
Automated testing of alarm outputs.
Defining the measurement value for the low analogue output.
Defining the measurement value for the high analogue output.
Choosing between 4-20mA, 0-20mA, or 0-5V outputs.
Specifying output behavior during fault conditions.
Determining which faults trigger the analogue output fault mode.
Testing the functionality of the analogue output.
Automated testing of the analogue output.
Choosing the appropriate sensor for the 7200 Monitor.
Setting the measurement range and resolution.
Adjusting signal damping for stable readings.
Enabling the air clean function for compatible sensors.
Choosing the equation for calculating measured values.
Restoring factory default sensor settings.
Setting or editing the displayed measurement title.
Selecting or editing units for the displayed measurement.
Setting or changing the instrument's password.
Restoring instrument to factory default settings.
Determining the time between sensor cleaning cycles.
Selecting between Normal and Reverse clean modes.
Monitoring sensor service life based on cleans.
Resetting the sensor clean count after servicing.
Determining the time between air clean cycles.
Setting the duration of the air pump operation.
Time after cleaning before measurements resume.
Monitoring air pump service life based on runtime.
Resetting the air clean count after servicing.
Displaying raw and processed sensor input signals.
Additional values for diagnosing instrument problems.
Downloading calibration and internal values via RS232.
Viewing measurement statistics and setting average period.
Displaying software version and serial number.
Partech contact details for support.
Locking the instrument configuration with a password.
Modifying the instrument's user password.
Error messages related to sensor detection and input.
Error messages related to display range issues.
Error messages related to sensor cleaning cycles.
Error messages encountered during calibration.
Error messages related to the air clean pump.
Instructions and address for returning equipment for service.
Overview of general specifications like voltage, temperature, etc.
Specifications for alarm and analogue output types and ratings.
Details EMC standards and physical/environmental ratings.
To Next Page