Partner PT-6200 - Superio Device

25
► SuperIO Device
Use this item to change settings for I/O devices. Select the item and press <Enter> to open the following
menu:
Onboard Serial Port 1/2
These items are used to assign the I/O address and IRQ for the onboard serial port 1/2. The default setting is
(3F8/IRQ4) / (2F8/IRQ3).
Serial Port 1/2 Use IRQ
These items allow you to select an corresponding interrupt for the third and fourth serial ports. The default
setting is IRQ4/IRQ3.
UART Mode Select
This item allows you to enable or disable built-in IR (Infrared) transmission feature. The default setting is
Normal.
Option Description
Normal Disable IR transmission feature and disable standard (COM2)settings, a default setting.
IrDA One of IR transmission protocols at a rate of 115.2Kbps.
ASKIR One of IR transmission protocols at a rate of 56Kbps.
SuperIO Device Figure 2.9
submenu
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
Onboard Serial Port 1 [3F8]
Serial Port 1 Use IRQ [IRQ4]
Onboard Serial Port 2 [2F8]
Serial Port 2 Use IRQ [IRQ3]
UART Mode Select [Normal]
Item Help
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults