Revision 25 of DOCU225, © Copyright
These modes include pre-selected sets of WITS codes, described in Default Pason
WITS Codes on page 32.
Tip:
Use the search box on the WITS setup screen to quickly jump to a specific WITS code.
To select standard WITS codes for a Pason computer to send, follow this procedure:
1. From the EDR main screen, click Menu > Setup > WITS. The WITS setup
screen opens.
2. Click the tab of the Pason computer you want to send the WITS codes, and
ensure that the Standard button is selected.
3. To select a preconfigured setting, click Full WITS or Half WITS.
Or,
4. To select outgoing WITS codes individually, click on an unselected WITS code’s
Enable check box.
5. Select the Transmission type and Interval for the selected group of WITS
codes. The transmission type and interval apply to all WITS codes in the group.
6. Select the display Unit, and type of Data Summary from the drop-down lists.
See Table 1 above for more information about these selections.
7. If desired, you can click in a code’s row, and enter a new WITS code for that row.
Any standard WITS code that you have changed displays a Reset button. If you
enter a WITS code that is already in use, click the Reset button to change back
to the default Pason WITS code.
8. When you are finished, click Save > Exit to return to the Setup Menu. The Pason
computer starts sending the selected WITS codes.
To Next Page
Loading...