PATON ProTIG AC/DC TIG/MMA - 26 -
- Have read the "Safety instructions" section and the safety precautions in this
manual and confirm this with their signature
.
14.3 Personal protective equipment
Observe the following rules for personal protection:
-
Wear sturdy shoes that retain their insulating properties, including in wet
conditions
;
-
Protect your hands with insulating gloves;
-
Protect your eyes with a protective mask with a UV filter that meets safety
standards
;
-
Use appropriate inflammable clothing.
14.4 Hazard of harmful gases and vapors
-
Remove any smoke and harmful gases from the workspace using special means;
-
Ensure an adequate supply of fresh air;
-
Solvent vapors must not enter the radiation zone of the welding arc
14.5 Sparking hazard
-
Flammable objects must be removed from the workspace;
-
Welding work is not allowed on containers storing or having stored gases, fuels,
petroleum products. There may be a risk of explosion of residues of these products
;
-
Special rules according to national and international regulations must be
observed in fire and explosion hazardous area
.
14.6 Hazard of mains and welding currents
-
Electrical shock can be fatal;
-
Magnetic fields generated by high currents can have a negative effect on the
function of electrical devices (e.g. pacemakers). Persons wearing such devices should
consult a physician before approaching the welding site
;
-
Welding cable must be strong, undamaged and insulated. Loose connections
and damaged cables must be replaced immediately. All mains and welding machine
cables should be checked regularly for correct insulation by an electrician;
-
The outer cover of the machine must not be removed during operation.
14.7 Informal safety precautions
-
Keep the manual close to the place of use of the welding machine at all
times
;
-
In addition to the instructions, comply with the general and local safety
and environmental regulations in force
;
-
Keep all the instructions on the welding machine in a legible condition.
To Next Page
Loading...
