- 27 - PATON ProTIG AC/DC TIG/MMA
14.8 Stray welding currents
-
Make sure that the ground cable is firmly connected to the piece;
-
If possible, do not place the welding machine directly on the conductive surface
of the floor or work table. Use insulating pads
.
14.9 Common precautions
Check the machine at least once a week for external damage and operation of the
safety devices
.
15. WARRANTY OBLIGATIONS
PATON INTERNATIONAL warrants that the source will operate properly if the user follows the
operating, storage and transportation conditions.
WARNING! There is no free warranty service if the welding machine is mechanically
damaged!
Machine model
Warranty period
ProTIG-200 AC/DC
2 years
The main warranty period is calculated from the date of sale of the inverter equipment to the
end customer.
During the main warranty period, the seller undertakes, at no charge to the owner of the
PATON inverter equipment:
- To make a diagnostic and identify the cause of the breakdown,
- To provide the units and elements necessary for repair, - replace defective components and
units, - To test the repaired equipment.
The main warranty does not cover the equipmen:
- With mechanical damage that affects the performance of the equipment (deformation of the
housing and parts as a result of falling from a height or falling of heavy objects on the
equipment, falling out of the buttons and connectors),
- With traces of corrosion, which caused the defective condition,
- Failed due to exposure of its power and electronic components to excessive moisture,
- Failed due to accumulation of conductive dust inside (coal dust, metal chips, etc.), - In the
case of an unauthorized attempt to repair its components and/or replace the electronic
elements,
- Depending on the operating conditions, it is recommended to remove the protective cover
and clean the internal elements and units with compressed air once every six months to avoid
the failure of the device. Cleaning should be carried out carefully, keeping the compressor
To Next Page
Loading...
