VCCs
voltages that control the fans and the CPU
core. If the values deviate by an amount greater
than the values installed here, the hardware
monitoring will alert you with a warning.
Change Password
If you highlight this item and press Enter, a dialog box appears
which lets you enter a Supervisor password. You can enter no
more than six letters or numbers. Press Enter after you have typed
in the password. A second dialog box asks you to retype the
password for confirmation. Press Enter after you have retyped it
correctly. The password is required at boot time, or when the user
enters the setup utility.
Change or Remove the Password
Highlight this item and type in the current password. At the next
dialog box, type in the new password, or just press Enter to disable
password protection.
Exit
Highlight this item and press Enter to save the changes that you
have made in the setup utility and exit the setup program. When
the Save and Exit dialog box appears, press Y to save and exit, or
press N to exit without saving.
To Next Page
Loading...
