Page 11 of 24
TAMPER EVIDENT NECK BANDING AND SHRINKSLEEVE LABELING MACHINERY
8 Sheehan Avenue, South Norwalk, CT 06854 USA 203-853-1516 F 203-854-0834 www.pdc-corp.com
4.3 Tunnel Temperature Controller
At the front of the tunnel, turn the tunnel electronic temperature control power
switch (green) to “on”. This green switch turns on the KST80-712 tunnel.
After turning this switch, the tunnel temperature will rise to the temperature setting
on the controller. To change the temperature, push either of the buttons, marked
with the up or down arrow, to raise or lower the temperature, respectively.
Read the supplied temperature controller manual (blue manual from Red Lion) in
the Literature section that accompanies this manual, before making any other
changes to the temperature controller settings.
To Next Page
Loading...