Page 17 of 24
TAMPER EVIDENT NECK BANDING AND SHRINKSLEEVE LABELING MACHINERY
8 Sheehan Avenue, South Norwalk, CT 06854 USA 203-853-1516 F 203-854-0834 www.pdc-corp.com
5.2 Steam Valve Direction Control
The spray pipes can be rotated to direct the steam where it is required for the
shrink process. Loosen the pipe union with the supplied 1-1/8” open-end wrench
and then use the steam tunnel wrench (shown below) to rotate the spray pipe to
position (see following page).
Loosening the Union Steam Tunnel Wrench
PDC Part # PDC-231A00
To Next Page
Loading...