VENTLESS HOOD OPERATING INSTRUCTIONS
MODELS VL30 / VL50
WIRING
The Peerless oven has been prewired to your hood at the factory. Have a
hood and install them on L1 and L3 on the terminal block of the oven.
The electrical service for the entire unit goes to the electrical box on the
hood. Wire amp service and run to the top of the contractor in the electrical
box on the hood. (VL30 requires 50 amp, VL50 requires 60 amp)
diagram on page 22.
TO TURN ON VENTLESS HOOD:
1. Turn on toggle switch located on the side of the control box near the
back of the hood
2. Press the black reset button also located on the control panel and hold
for 5 seconds
3. Turn the toggle located on the front of the oven to the ON position
4. Follow instructions located in this manual for additional operating
instructions.
19
To Next Page
Loading...
