CE SERIES PARTS REPLACEMENT INSTRUCTIONS
CONTROLLER Disconnect from power
Remove screws on lower front to access control
Remove controller and mount replacement
Carefully replace wires to the proper terminals
SOLID STATE RELAY Disconnect from power
Remove back cover
Remove relay and mount replacement
Carefully replace wires to the proper terminals
CALROD ELEMENTS Disconnect from power
Remove back cover
Remove wires from desired element
Open door, remove fasteners and remove stone
and steel deck
Remove elements
Reverse procedure
COOLING FAN Disconnect from power
Remove screws on lower front to access fan
Remove fan and mount replacement fan
Unplug old fan and plug in new fan
Replace front
DOOR HINGE PINS Hinge place assembly is fastened to door frame
Remove door weights, both sides
Remove screws and move door forward enough
to slide hinge pin clear of frame
Insert new pin and mount to frame using new
screws provided
Old units may require drilling out of the screw
heads and drilling new holes
In this case, you may have to rotate hinges
6
To Next Page
Loading...
