To Next PageTo Next Page
Need help?Do you have a question about the Pegasus M800 and is the answer not in the manual?
General| Brand | Pegasus |
|---|---|
| Model | M800 |
| Category | Sewing Machine |
| Language | English |
Attracts user attention to specific points and warnings.
Covers maintenance safety, pre-operation checks, and operator training.
Protects eyes from broken needle fragments.
Prevents needle contact with fingers during operation.
Covers looper for safety during operation.
Covers looper mechanism for safety.
Covers pulley and belt for safety.
Never operate with the needle breakage shield open.
Never insert fingers into the interstice near the needle.
Never remove the pulley cover.
Check pulley rotation direction; should be clockwise.
Never insert fingers into the interstice under the presser foot.
Diagram showing semi-submerged table mounting.
Machine pulley rotates clockwise when viewed from the pulley.
Connects presser foot lift lever and treadle; adjust chain length.
Use Pegasus recommended oil; other oils may damage the machine.
Fill oil until level is between H and L lines.
H is upper limit, L is lower limit for oil level.
Procedure for hand-oiling key machine parts.
Open specific parts before threading and reassemble after.
Knot new thread to existing thread for rethreading.
Thread machine following the diagram attached.
Resharpen lower knife accurately as illustrated.
Requires special grinder; contact dealer or Pegasus.
Remove drain screw to drain oil.
Standard installation positions for M832 thread guides.
Standard installation positions for M852 thread guides.
