Page 31
USER MANUAL
2. To access the second programming level press the UP (t) and DOWN (u) keys and the
WATER DISCHARGE key simultaneously for a few seconds. When the first programming
variable appears the system automatically goes to stand-by.
- Select the variable to be modified by pressing the UP (t) or DOWN (u) keys.
- When the parameter has been selected it is possible to:
- View the setting by pressing the SET key.
- Modify the setting by holding the SET key down and pressing the (t) or (u) key.
- When configuration settings have been completed you can exit the menu by pressing the (t) and
(u) keys simultaneously and keeping them pressed until the room humidity value (0.0 on ON/OFF
versions) reappears.
Changes are saved automatically when you exit the configuration menu.
Press the ON/OFF - STAND-BY key to enable electronic control (when you enter Level 2
programming the humidifier automatically goes to STAND-BY mode).
To Next Page
Loading...
Need help?
General
