Page 38
USER MANUAL
MAINTENANCE
To ensure working safety, correct functioning and an optimal output of EASYSTEAM humidifiers,
it is necessary to execute maintenance operations according to following instructions.
GENERAL SAFETY RULES
Every type of maintenance has to be done exclusively by experienced and qualified
technical staff, conscious about necessary safety.
Before starting any maintenance procedure, to proceed as follows:
1. If unit is out of service because of an alarm condition, to note the displayed error code.
2. To close the valve of water supply.
3. To put the humidifier in stand-by using the proper key and discharge completely the water
contained in the cylinder using the key “Manual water emptying” on Slim Controller (see chap.
3).
4. To disconnect the unit from the electric system sectioning the power input permanently
padlocking it on OFF.
5. To wait the cylinder and the humidifier have cooled or to use protection gloves.
6. Each unit element, if it is defective, has to be replaced exclusively with original spare parts.
MAINTENANCE INTERVALS
Following are indicated the maintenance operations to execute and their suggested frequency.
Being electrodes consumption and incrustations and solid deposits formation into the cylinder
variables according to the type of water (also with the same conductivity), it could be necessary to
modify these intervals.
To verify this need checking the deposits quantity into the cylinder; a quickly accumulation of
incrustations and deposits requires to increase the suggested maintenance frequency and/or the de-
concentration discharges parameters variation.
To minimize residual formation on the bottom of cylinder it’s advisable to increase
deconcentration drain frequency reducing value of S2 parameter. This trick has
disadvantage of bigger water and energy consumption.
CHAP. 7 MAINTENANCE
To Next Page
Loading...
Need help?
General
