Installer Manual Performa 263-268 / LOGIX 740-760 - Programming
Ref. MKT-IM-011 / A - 15.06.2017 31 / 64
10. "MIN"
Indicates that the value entered / displayed is in minute increments.
11. "g/L"
Indicates that the value entered / displayed is in grams / Liter.
12. "KG" Indicates that the value entered / displayed is in kilograms or
kilograins.
13. "x100"
x100 multiplier for large values.
14. "Lbs/ft
3
"
Indicates that the value entered / displayed for regenerant amount is in
pounds per cubic foot.
15. Faucet Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
16. Maintenance interval Displayed when the month in service exceed the value programmed in
parameter P11.
17. Digits
Four digits used to display the time, program value or error codes.
18. Number Used with #19, #20 and #21.
Displays a sequence number or value.
19. History values (H) The number displayed by #18 identifies which history value is currently
displayed.
20. Parameter (P) Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
21. Cycle (C) The number displayed by #18 is the current cycle in the regeneration
sequence.
22. Hardness
Hardness setting - only used with 760 and 762 controllers.
23. Capacity
Shows estimated system capacity.
24. "x2"
Indicates a second regeneration has been called for.
25. Recycle sign Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
26. Salt Programming the amount of regenerant.
If the controller is on a 3-cycle filter then the backwash time is
displayed.
27. Regeneration time and
day
Programming the time of regeneration and the days of regeneration.
28. Time and day
Programming the current time and day.
To Next Page
Loading...
