Pentair EVERPURE PRO - Drain Clamp Installation

EVERPURE
®
PRO-Reverse Osmosis Water Filtration System Installation and Operating Instructions • 7
5. Lubricate the o-rings on the bottom of the faucet spout
with supplied silicone lubricant. Use lubricant
sparingly (Figure 8).
Figure 8
6. Insert goose-neck spout into faucet base firmly (Figure 9).
Figure 9
Installing the Drain Clamp
NOTE: If you have a single-basin sink with a disposal unit,
call Technical Support at 1-800-279-9404 for options.
NOTE: Before installing the drain clamp, check the drain
pipes under the sink for corrosion. Corroded pipes
should be replaced before continuing with
the installation.
1. Attach the drain clamp to a vertical section of the
drainpipe, about 6 inches above the trap. Make sure the
opening on the drain clamp is facing towards the drinking
water faucet (Figure 10).
6 inches
Figure 10
2. Using the fitting hole of the drain clamp as a guide, drill a
1/4-inch hole through one side of the drain pipe (Figure 11).
Figure 11
3. Remove the drain clamp from the drainpipe and enlarge
the hole with a 3/8-inch drill bit (Figure 12). Use a file to
remove rough edges from the drilled hole.
Figure 12
4. Make sure the black rubber gasket is adhered to the inside
of the drain clamp and place the drain clamp assembly
over the drilled hole. Look through the hole and position
the clamp so that the center of the clamp hole is slightly
higher (about 1/16 inch) than the center of the drilled hole.
(Figure 13). Tighten the clamp securely.
Figure 13
5. Screw the plastic compression nut onto the drain clamp
until hand-tight (Figure 14).
Figure 14