8 • EVERPURE
®
PRO-Reverse Osmosis Water Filtration System Installation and Operating Instructions
Connecting the Faucet to the Drain
NOTE: This is a gravity drain line. Any loops, kinks or sharp
bends must be eliminated before proceeding. Failure
to create a straight line to the drain may result in
reject water leaking through the air gap in the faucet
onto the counter top and below the faucet.
1. Align the white 3/8-inch tubing from the faucet with the
compression nut on the drain clamp. Create as straight a path
as possible with the tubing. Cut the tubing squarely below the
nut and remove the internal and external burrs (Figure 15).
Figure 15
2. Loosen the compression nut two complete turns. Insert the
tubing into the nut until it stops. Tighten with fingers, then
tighten 1 to 2 turns with a wrench (Figure 16).
Figure 16
Installation of Mounting Screws
When tank is full, it weighs approximately 40
pounds. Provide ample support under the tank.
If system is being installed under the kitchen sink, locate it
on back or right side wall. Make sure to allow ample space
for installation. To change the filter cartridges, a minimum
of 1-1/2 inches of clearance is required underneath the filter
housings. A minimum of 2 inches of clearance from the left
side of the unit is also required or 6 inches from the left
bracket mounting screw hole.
Install mounting screws at least 13-3/4 inches from cabinet
floor and 5-3/8 inches apart. Leave a 5/16 inch space between
the head of the screw and the wall to slip bracket onto screws.
Figure 17
To Next Page
Loading...
