4007090 REV B SE23
13845 Bishops Dr. | Suite 200 | Brookeld, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404 | tech-support@pentair.com | pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
© 2023 Pentair. All rights reserved.
13845 Bishops Dr. | Suite 200
Brookeld, WI 53005 | United States
P: 262.238.4400 | Customer Service: 800.279.9404
tech-support@pentair.com | pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and
unregistered trademarks and logos are the property of their respective owners.
© 2023 Pentair. All rights reserved.
To Choose Sensor Regeneration Type
From the XTR2 main Master Settings screen, press the valve button to display the
valve screen.
Press the regen. type button and scroll through the options until the tank sensors
option is seen. Press the check mark button to select.
NOTE: Hardness and hardness units settings will no longer be available when in the
regen. type; tank sensors mode.
Follow the setup instructions outlined in the Fleck 5800 XTR2 Service Manual
as you power up the system.
BEGIN VALVE SETUP
Should you have questions about setup, contact Pentair Tech Support
at tech-support@pentair.com.
To Previous Page
Loading...
