WHOLE HOUSE WATER SOFTENING SYSTEM • 11
QUICK START GUIDE: SYSTEM START-UP INSTRUCTIONS
1. Connect the unit to the existing plumbing
(Facing the front of the system, the INLET is on the LEFT –the OUTLET is on the RIGHT)
The bypass is only hand tightened at the factory and must be fully tightened and checked for leaks
by installer.
Connect the drain line to a proper location; adhere to ALL LOCAL and STATE CODES.
When turning the water back on, leave the system in bypass mode and then turn water on to house
and check for leaks. Run the cold water in bathtub or outdoor faucet to flush debris and air from
lines. (Bathtubs and outdoor faucets do not have aerators that may plug with debris.) Then once the
programming is complete, follow start up procedure starting at step 10.
2. Understanding the face plate
There are 3 buttons on the face of the unit.
The button on the left with the 2 arrows in a circle is called the scroll button.
To the right are the up and down button.
3. Programing the system
To begin, place the control into the service mode.
Press and hold the DOWN arrow for 5 seconds; the control will display: SYSTEM CHECK
Then enter the following code by pressing and releasing the following buttons.
DOWN, DOWN, SCROLL, DOWN, THIS MUST BE DONE WITHIN 10 SEC. or the control will
return to the home screen. The screen will display “UNIT SIZE 1.5”. Use the UP or DOWN arrow to set the
size of the system, 1.0, 1.5, or 2.0.
4. Set the Hardness
Press the SCROLL to advance to the next setting.
The control will display “WATER HARD: 20 GRN” use the UP or DOWN arrow to adjust to correct
hardness of the water (if iron is present adjust Hardness +5 for every 1ppm of iron). When you adjust the
hardness, the unit will change the necessary settings automatically.
5. Salt Setting
Press the SCROLL to advance to the next setting.
The control will display “SALT LEVEL: MED”. This is the standard setting. In most all cases leave at the
factory setting.
If the hardness is above 50 grains use the UP arrow to change to “HIGH”.
If it’s 10 or less you may use the DOWN button to change to “LOW”. Note Using a low salt setting will
save salt but the system will use twice as much water.
The refill time will adjust automatically to use more or less salt to REGENERATE.
6. Enter desired phone number.
Press the SCROLL button to advance to the next setting.
The screen will read “CHANGE PHONE? NO” use
DOWN button change to “YES” Press the SCROLL button 1 time and the 1st number will flash.
Use the UP or DOWN button to program your phone number to display. After each number
press the SCROLL button 1 time to advance to the next number. After setting all the numbers, press
SCROLL to advance to the next setting.
7. The control will display “TIME OF DAY”, press the UP or DOWN arrow to program the time of day.
Notice
To Next Page
Loading...
