20 • WHOLE HOUSE WATER SOFTENING SYSTEM
SANITIZING THE SOFTENER
The unit may be sanitized with or without salt in the brine tank.
After the installation is complete, the following procedure can be used to sanitize the water conditioner:
1. Mix a 3/4 cup of common (unscented) 5.25% household bleach with 1 quart of water. Pour this
solution into the brine well.
Do not pour undiluted bleach into the water conditioner.
2. Initiate a manual regeneration. The solution will be drawn into the water conditioner during the
regeneration process.
3. When the regeneration is complete, the water conditioner has been sanitized.
Notice
Notice
To Next Page
Loading...
