WHOLE HOUSE WATER SOFTENING SYSTEM • 3
APPLICATION LIMITATIONS
• This system may be applied on municipality or well water systems. On hardness levels of 60 grains
and higher, the system may not achieve a hardness of less than 1 grain, due to high Total Dissolved
Solids (some bleed through is possible). Bleed through can also be caused by sodium levels higher
than 1000 ppm. In either case, your system can be programmed to minimize these effects.
See page 10.
• When this system is installed on water with ferrous iron, also known as clear water iron, the maximum
range of reduction is based on local water conditions. The range is generally below 3 parts per
million. Your equipment may require special programming, along with an additive to the brine tank,
to maximize the equipment’s ability to reduce iron. See page 10.
To Next Page
Loading...
