WHOLE HOUSE WATER SOFTENING SYSTEM • 15
3. SALT LEVEL
The control will display:
• Press the UP or DOWN ARROW to select Low, Medium, or High. Medium is a good setting for most
circumstances. For small families and low hardness, Low will provide greater salt efficiency. For large
families and high hardness, High will provide the most capacity.
Press the SCROLL BUTTON to advance to the next setting.
4. SERVICE PHONE NUMBER
The control will display:
If you do not want to change the phone number, leave this setting at NO. Press SCROLL to advance to the
next setting.
To change the number, select YES; Press the UP or DOWN ARROW and then enter the service phone
number. Press SCROLL to advance through the digits. After setting the number, press SCROLL to advance
to the next setting.
5. TIME OF DAY
The control will display:
• Press the UP or DOWN ARROW to program the time of day.
Press SCROLL BUTTON to advance to the next setting
The control will display:
If you want to go to the advanced settings, press the UP or DOWN ARROW, change to YES and press the
scroll button. (see ADVANCED MENU on page 16)
If you do not want to access the advanced settings, leave this at NO. Press Scroll to advance to
the Exit screen.
Press the DOWN ARROW to exit the Installer’s Level.
Notice
If you need to recheck settings or make a change, pressing SCROLL when “EXIT” is displayed will take you
back to the start of Installer Settings.
To active the new settings, you must execute a complete regeneration. If you DO NOT manually
regenerate the system, the settings WILL NOT become active until the unit has completed the next
scheduled regeneration.
Salt Level: Med
Change Phone? No
000-000-0000
Set Time of Day
To Exit Press Down Arrow
Go to ADVANCED menu? No
CAUTION
To Next Page
Loading...
