No. NAME FUNCTION
1 RGB Video Output NTSC or PAL RGB video out connectors, 9-pin D-sub Female connectors.
2 Interface Connector For RS-232C interface.
3 Keyboard Connector accepts the keyboard supplied by Pentax.
4 Separated Video Output Y/C video out connector (4-pin S connector), two (2) outputs on rear panel
5 Composite Video Output NTSC or PAL composite video out connector, BNC type connector, two (2) outputs on
rear panel.
6 Control is activated by either the endoscope control buttons (C, V) or the processor front panel
copy switch to control peripherals.
7 Lamp Life Meter Indicates hours for Metal Halide lamp installed in video processor. Check the lamp life hour
meter on the rear panel frequently, a lamp with 200 hours or more should be replaced before
beginning a procedure. To replace the lamp, contact your local Pentax service center.
8Breaker activates with a red button protruded out when abnormal current flows.
-When the breaker is activated, try to reset first. If the breaker activates
again, when the processor is turned ON, do NOT use the processor and return it to
Pentax.
9 Power Input Socket Accepts AC power cord.
10 Rating Plate Displays unit model number, serial number, power requirements.
CAUTION
To Next Page
Loading...
