Pentax K200D - Setting the File Format

144
Shooting Settings
6
Setting the Image Processing Method
in Capture Mode (Custom Image)
You can set Custom Image when the exposure mode is set to e
(Program), K (Sensitivity Priority), b (Shutter Priority), c (Aperture
Priority), a (Manual) or p (Bulb). By using Custom Image to change the
[Image Tone], you can adjust settings such as the color and contrast
before shooting an image.
Select from the following six modes for Image Tone: Bright, Natural,
Portrait, Landscape, Vibrant and Monochrome. The default setting is
[Bright].
You can adjust the following items for Image Tone.
*1 This can be set when any mode other than [Monochrome] is selected.
*2 This can be set when [Monochrome] is selected.
1 Press the { button in Capture
mode.
The Fn menu appears.
Saturation
*1
Sets the color saturation. (Available settings: –4 to +4)
Hue
*1
Sets the color. (Available settings: –4 to +4)
Contrast Sets the image contrast. (Available settings: –4 to +4)
Sharpness
Sets the sharpness of the image outlines. (Available
settings: –4 to +4)
Filter Effect
*2
Changes the contrast to appear as if a B&W color filter was
used. Sets the filter color. (Available settings: [None],
[Green], [Yellow], [Orange], [Red], [Magenta], [Blue], [Cyan],
[Infrared Color])
Toning
*2
Sets the level for cold tone adjustment (– direction) and
warm tone adjustment (+ direction). (Available settings:
–4 to +4)
Fn
AUTO
AUTO
AUTO
CUSTOM IMAGE
OK
Exit
E x it
Exit
Fn