Pentax Optio W30 - Page 95

93
4
Taking Pictures
5 Press the 4 button.
The White Balance setting is saved.
6 Press the 3 button.
The camera returns to capture status with the current setting.
Refer to “Manual Setting” below for instructions on adjusting the white
balance manually.
Have a blank sheet of white paper or similar material ready.
1 In the White balance screen, use the four-way controller
(23) to select K (Manual).
2 Point the camera at the blank
sheet of paper or other material so
that it fills the frame displayed in
the center of the screen.
3 Press the shutter release button
fully.
The white balance is automatically adjusted.
4 Press the 4 button.
The setting is saved and the screen returns to the [A Rec.Mode].
5 Press the 3 button.
The camera returns to capture status.
If you use the [White Balance] function frequently, you can save time
by assigning it to the Green button. (p.58)
Saving the White Balance 1p.104
Manual Setting
MENU
Adjust
SHUTTER
White Balance
Cancel
C a n c e l
OK
O K
OKCancel
OK