USER MANUAL
Peplink Balance Series
http://www.peplink.com -127 / 261 - Copyright © 2015 Peplink
By default, Auto is selected for as the Default Rule. You can select Custom to change
the algorithm to be used. Please refer to the upcoming sections for the details on the
available algorithms.
To create a custom rule, click Add Rule at the bottom of the table. The following
window will be displayed:
This setting specifies the name of the outbound traffic rule.
This setting specifies whether the outbound traffic rule takes effect. When Enable is
checked, the rule takes effect: traffic is matched and actions are taken by the Peplink
Balance based on the other parameters of the rule. When Enable is unchecked, the rule
does not take effect: the Peplink Balance disregards the other parameters of the rule.
This setting specifies the source IP address, IP network, or MAC address for traffic that
matches the rule.
To Next Page
Loading...
