USER MANUAL
Peplink Balance Series
http://www.peplink.com -190 / 261 - Copyright © 2015 Peplink
Access points to manage can be specified here. If Any is selected, the AP controller will
manage any AP that reports to it. If Approved List is selected, only APs with serial
numbers listed in the provided text box will be managed.
23.2 Wireless SSID
Wireless network settings, including the name of the network (SSID) and security policy,
can be defined and managed in this section. After defining a wireless network, users
can choose the network in AP Profiles.
Click the button New SSID to create a new network profile, or click the existing network
profile to modify its settings.
This setting specifies the SSID of the virtual AP to be scanned by Wi-Fi clients.
This setting specifies the VLAN ID to be tagged on all outgoing packets
generated from this wireless network (i.e., packets that travel from the Wi-Fi
segment through the Pepwave AP One unit to the Ethernet segment via the LAN
port). The default value of this setting is 0, which means VLAN tagging is
disabled (instead of tagged with zero).
This setting specifies whether or not Wi-Fi clients can scan the SSID of this
wireless network. Broadcast SSID is enabled by default.
To Next Page
Loading...
